Centrix SA1DK Manual de instrucciones Pagina 1

SA1DPInstruction Manual

1011. The BL-D40 External Sounder12. Programming the SA1DPTable 1 : Programming MenuTheBL-D40ExternalSounderiscompatiblewiththeSA1DK,SA1DP,A

1112.1 Entering Programming Mode1. Press the # key for two seconds. The Mode LED turns off and the Door LED turns red.2. Enter your 4-digit Program

1212.3 Changing Open Code 1Open Code 1 is mainly used as a method to quickly test the Lock Strike Relay during installation.The Default Factory Settin

1312.5 Changing the Programming Code1. Enter Programming Mode.2. Press “3” to enter Menu 3. The Mode LED turns green.3. Enter the new 4-digit code

1412.7 Changing the Normal/Bypass Code and Door Chime SettingsThe Normal/Bypass Code is also used to turn the Door Chime off and on.1. Enter Programmi

1512.9 Enrolling Primary and Secondary Codes12.9.1 Primary Codes •PrimaryCodescanonlybeenrolledtoanemptyuserSlot,meaningaslotwherethe

1612.9.4 Enrolling Primary and Secondary Codes using the Standard Method1. Enter Programming Mode.2. Press “7” to enter Menu 7. The Door LED turns

1712.9.5 Enrolling Secondary Codes Using the Code Search MethodThe Code Search feature enables you to quickly enroll a Secondary Code to a user who al

1812.10 Deleting Primary and Secondary CodesThere are two methods to delete Primary and Secondary Codes : the Standard Method and the Code Search Meth

1912.11 Return to Factory Default SettingsWARNING!! Be very careful before using this command as it will erase the entire memory, including all User a

CONTENT1. Introduction 1.1 Equipment 1.2 Additional Equipment2. Technical Specications3. Key Features4. Installation 4.1 Mounting 4.2 Wiring5. Wi

SA1DPInstruction Manual

3The SA1DP is a proximity card and keypad access control unit. The unit accepts up to 500 users and provides entry via the use of proximity cards and/

4The following are some of the SA1DP key features : •Built-inProximityCardReader(125KHzASKModulation) •Built-inKeypadforPINcodeentry •

54.2 Wiring2 of the typical wiring diagrams are illustrated below (see Figure 3 & 4 in Wiring Diagrams).Figure 1 : SA1DP Controller - Labeled Diag

6Figure 4 : Wiring the BL-D40 External SounderSA1DPThe SA1DP accepts up to 500 users and provides entry via the use of proximity cards and/or PIN code

7The SA1DP has three modes of operation :•Normalmode-ModelLEDisgreen. Normal Mode is the default mode. In Normal Mode, the door is locked unti

88. Changing the Modes of Operation8.1 Changing from Normal to Secure ModeFor the Normal Mode, the Mode LED is greenThe default factory setting for th

99. The Request to Exit (REX) Button10. Case and Back Tamper8.4 Changing from Bypass Mode to Normal ModeFor the Bypass Mode, the Mode LED is orangeSee